ok, there is no perl forum, so 'general' it is...

I am trying to run Darwin on my 2k server with perl 5.8.2 installed. I installed perl fine and it works well with other apps...

but when I try to install Darwin, it tells me my perl is not insalled correctly.

on install of Darwin, it goes fine (creates directories, unpakcks everything just fine, etc), until close to the last steps where I setup admin/pass and then I get the following error message;

Perl is not properly installed on your system. please make sure that the path to the Perl interpreter is in your system path and run ..\streamingadminserver.pl

is anyone here familiar with Darwin or Perl?